Carlton 2518 Manual del operador descargar pdf (Pagina 53)

18” DRUM MACHINE CONTROLS

26

• Two hydraulic valves control the winch

on this chipper. The hydraulic selector

valve diverts hydraulic fluid from the

feed roller circuit and enables the

hydraulic winch circuit. Once the

hydraulic winch circuit is enabled the

winch control valve controls the

hydraulic winch motor.

• The chipper winch selector switch is

located on the hydraulic control lever

panel. There is a decal that shows the

proper operation (pictured at the right).

Push the switch to the left to turn the

feed wheels on and to the right to turn

the winch on.

• The winch control lever is the third lever

on the hydraulic control lever panel.

 There is a decal next to the lever to

show proper operation of the winch

control. After the rope has been

attached to the tree, push the lever in

to pull the tree to the chipper. Also

use this lever position to rewind the

rope.

 Pull the lever back to release the

pressure on the rope to remove the

rope from the tree once it has been

pulled to the chipper and has been

put into position to be run through

the chipper.

 After use of the winch is finished use

the winch control lever to rewind and

secure the rope before running the

feed wheels. (The winch selector

will have to be turned back to the

Feed Wheels On position to feed the

tree through the chipper.)

• NEVER ALLOW ANYONE TO

OPERATE THE WINCH CONTROL

VALVE WHILE AN OPERATOR IS

IN THE VICINITY OF THE WINCH

ROPE!!! ROPE BURNS OR OTHER

INJURIES COULD OCCUR IF THE

PERSON BECAME ENTANGLED OR

TRIPPED BY THE ROPE.

HYDRAULIC WINCH

SELECTOR VALVE SWITCH

HYDRAULIC WINCH

CONTROL VALVE

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 198 199

Comentarios a estos manuales

Sin comentarios