Carlton 2518 Manual del operador descargar pdf (Pagina 102)

18” DRUM SERVICE

CUTTER SYSTEM

• Checking and setting the clearance by

the knife that is the closest to the anvil

will be the best place to start.

• If clearance needs to be adjusted, loosen

the six anvil bolts; just loose enough to

be able to move the anvil with the

adjuster bolts.

• To move the anvil closer to the knife,

loosen the nuts on the adjustment bolts

that are on the far side of the plate (see

the picture on the right). There are two

adjustment bolts as shown above.

• Using the nuts on the inside of the plate,

turn the nuts counterclockwise to move

the anvil closer to the knife. This will

shorten the clearance if it was too wide.

Make slight adjustments on each bolt

and recheck the clearance before making

more adjustments. When the clearance

has been set, recheck clearance on the

other knives.

• If the clearance is too narrow for the

feeler gage to go in easily, you will need

to loosen the nuts on the inside of the

plate and turn the outside nuts

clockwise. This will move the anvil

farther away from the knife. Make slight

adjustments on each bolt and recheck the

clearance before making more

adjustments. When the clearance has

been set, recheck clearance on the other

knives.

ANVIL BOLTS

ANVIL ADJUSTMENT BOLTS

TIGHTEN THE INSIDE NUTS TO SHORTEN THE

CLEARANCE BETWEEN THE KNIFE AND ANVIL

LOOSEN THE OUTSIDE NUTS

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 198 199

Sin comentarios

Carlton 2518 Manual del operador Pagina 102