Carlton 2518 Manual del operador descargar pdf (Pagina 44)

18” DRUM MACHINE CONTROLS

It is imperative that all operators are familiar with all controls of the chipper. This will make for

a much more productive and safer work period. (The actual controls may differ depending on

the engine supplied with your chipper.)

ENGINE CONTROLS:

• For the John Deere 170HP engine, the

Key Switch and Gauges are located in a

lockable panel at the rear of the engine.

Always turn off the engine and remove

the key from the switch before

performing service or maintenance of

any kind.

• The engine is supplied with a three-

position key switch. Turn the key

clockwise all the way to start the engine;

always start the engine at idle. When the

engine is running, release the key and it

returns to the on (run) position. Turn the

key counter-clockwise to shut down the

engine.

DO NOT OPERATE THE ENGINE

AT AN ANGLE GREATER THAN

25° OR SEVERE ENGINE DAMAGE

WILL OCCUR. PROPER ENGINE

OIL LEVEL MUST BE MAINTAINED

TO ACHIEVE MAXIMUM ANGLE

OF OPERATION OF 25°. (See Engine

Owner’s Manual for proper oil level.)

• A throttle switch is located next to the

key switch. The lower (idle) position is

for starting the engine, low speed engine

operation during warm up, clutch

engagement/disengagement, and engine

cool down. The upper position is for

running the engine at full speed during

chipping operations.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 198 199

Sin comentarios

Carlton 2518 Manual del operador Pagina 44