Carlton 2518 Manual del operador descargar pdf (Pagina 40)

18” DRUM DAILY CHECKLIST

13

• Inspect knife bolts and nuts for tightness

daily. It is very important to check knife

bolts and nuts after first hour of

operation for new bolts and nuts. It is

not uncommon for bolts to loosen

slightly during this time. The 18” drum

chipper knife bolts and nuts (3/4"-10)

are specially designed. Tighten and

torque to 235 ft. lbs.

• Inspect cutter drum knives for wear. Do

not operate the machine without a full

set of undamaged knives in place. Worn

or chipped knives will cause improper

operation of the chipper. (See Servicing

Cutter Drum Section to change or

sharpen knives and anvil.)

• Cutter drum must rotate freely. This will

help insure there are no foreign objects

inside the cutting chamber and there is

ample knife to anvil clearance. (The

cutter drum lock pin will have to be

pulled out of cutter drum to check

rotation. Replace pin after checking

rotation to perform further inspections.)

DO NOT ROTATE THE DRUM BY

HAND ALWAYS USE A PRY BAR.

• When inspection of cutter drum is

complete, close cutter drum door, insert

door lock pin and padlock. Make sure

door will not open. Check cutter drum

door hinges for damage and fit, replace

immediately if there is any damage or

misalignment.

CUTTER DRUM DOOR HINGES

DOOR PIN & PADLOCK

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 198 199

Comentarios a estos manuales

Sin comentarios