Carlton 2518 Manual del operador descargar pdf (Pagina 117)

18” DRUM SERVICE

FEED WHEEL MOTOR

WARNING:

 RELEASE HYDRAULIC PRESSURE BEFORE PERFORMING ANY SERVICE

TO HYDRAULIC LINES OR OTHER COMPONENTS.

 FLUID UNDER PRESSURE CAN PENETRATE THE SKIN AND CAUSE

SEVERE INJURY. SEEK IMMEDIATE MEDICAL ATTENTION IF SKIN IS

PENETRATED. CHECK HOSES AND FITTINGS USING A BOARD OR

CARDBOARD; DO NOT USE HAND OR FINGER. ALWAYS WEAR EYE

PROTECTION.

• Remove the rubber guard that covers the

feed wheel coupling and bushing by

removing the two 3/8” bolts. Be sure to

keep all parts and hardware together to

make reassembly easier.

• Before changing the feed wheel motor,

release the hydraulic pressure. Mark the

location of each hose, possibly with an R

and L for right and left hoses. Then

disconnect the hydraulic hoses and cap

the ends of hoses and the connections on

the motor.

• Remove the three bolts (3/8”) from the

bushing and screw these bolts back into

the three threaded holes in the bushing to

push the motor assembly off the

bushing. Screw these bolts in a little at a

time to take the assembly off without

applying more pressure to one side than

the other.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 198 199

Sin comentarios

Carlton 2518 Manual del operador Pagina 117