Carlton SP8018 TRX Especificaciones descargar pdf (Pagina 62)

SP8018 TRX SERVICING CUTTER WHEEL

42

OPTIONAL:

Sandvik

® Dura Disk II Cutter Wheel

• If the machine is supplied with the

optional Dura Disk II cutter wheel, there

are fifty (50) teeth to a complete set.

There are ten (10) Short Plow Bolt Bits

(Carlton part #0450121) and forty (40)

Plow Bolt Bits (Carlton part #0450120).

• DO NOT OPERATE A MACHINE

WITHOUT A COMPLETE

NUMBER OF TEETH IN THE

CUTTER WHEEL PROPERLY

INSTALLED. EXCESSIVE

MACHINE VIBRATION WILL

OCCUR CAUSING PREMATURE

BEARING FAILURE AND

EQUIPMENT DAMAGE.

• A locking pin is provided to hold cutter

wheel in position during tooth removal

and re-installation.

• The locking pin will only lock in the

deep slots of the outer teeth. Line the

slot up with the locking pin slot and

insert the pin to lock position. The pin

will need to be removed and reinserted

as wheel is rotated to change remaining

teeth.

• NEVER PLACE YOUR HAND ON

THE CUTTER WHEEL TO HOLD IT

IN PLACE WHILE CHANGING

TEETH.

• BE SURE TO REMOVE THE PIN

BEFORE OPERATING THE STUMP

CUTTER.

• The teeth do not require a setting gauge.

The only requirement is to be installed in

the proper direction and tightened to the

proper torque as discussed in the next

section.

• When replacing a cutter wheel tooth,

replace the tooth and nut as a set and

use anti-seize on the threads.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 100 101

Comentarios a estos manuales

Sin comentarios