Carlton SP8018 TRX Especificaciones descargar pdf (Pagina 41)

100

101

SP8018 TRX MACHINE OPERATION

STARTING - READ THIS MANUAL, ALL MACHINE DECALS, AND THE ENGINE

MANUAL BEFORE STARTING.

• Check all fluids before starting.

• Drive belts must be disengaged before starting.

• Inspect all connections, teeth, tracks, etc. (See Daily Checklist).

• Avoid transversing slopes. Ascend/descend hills straight up & down.

• DO NOT OPERATE THE ENGINE AT AN ANGLE GREATER THAN 25° OR

SEVERE ENGINE DAMAGE WILL OCCUR. PROPER ENGINE OIL LEVEL MUST

BE MAINTAINED TO ACHIEVE MAXIMUM ANGLE OF OPERATION OF 25°. (See

Engine Owner’s Manual for proper oil level.)

• DO NOT OPERATE AROUND WATER, GAS, POWER OR PHONE LINES. IF IN

DOUBT, CHECK BEFORE GRINDING.

• WEAR FACE SHIELD AND HEARING PROTECTION.

• KEEP CLEAR OF CUTTING WHEEL AND MOVING MACHINE PARTS.

• KEEP SPECTATORS AWAY.

• THE CLUTCH MUST BE

DISENGAGED BEFORE STARTING

THE MACHINE.

• The SP8018 TRX stump grinder is a

radio control machine. To start the

engine and radio control transmitter,

follow these instructions.

• On the machine, turn the ignition key

switch to ON, the machine switch to

Remote On, and make sure the flow and

gear switches are in the LOW position.

• On the transmitter, press the E-STOP

button down.

• Toggle any switch on the transmitter.

• Twist the E-STOP button clockwise to

release. Release the E-STOP button

within 10 seconds to power up or the

unit will power down. When the

transmitter is operating there is a yellow

light that will be flashing, the light is

indicated in the picture at the right.

(Read the radio control manual for more

information on the meaning of different

lights and colors.) If the transmitter

doesn’t start, check the transmitter for

stuck switches; it will not start with a

switch in the ON position.

TOGGLE ANY

SWITCH

E-STOP BUTTON

A YELLOW LIGHT

WILL BE FLASHING

WHEN RADIO IS

SENDING SIGNALS

TO THE RECEIVER

BATTERY LOW /

FAULT LIGHT

PUSH SWITCH UP

TO REMOTE ON

FLOW AND GEAR

SWITCHES MUST

BE IN LOW

KEY

SWITCH

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 100 101

Comentarios a estos manuales

Sin comentarios

Carlton SP8018 TRX Especificaciones Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Carlton SP8018 TRX