Carlton SP8018 TRX Especificaciones descargar pdf (Pagina 51)

SP8018 TRX TROUBLESHOOTING GUIDE

COMPLAINT

CAUSE CORRECTION

Roar in machine when

cutter wheel is engaged.

• Belt guards rubbing on

jackshaft or cutter wheel

shaft.

• Jackshaft or cutter wheel

bearings going bad.

• Re-position guards away

from shafts.

• Replace bearings.

Traction loss of power.

• Relief valve set too low.

• Hydraulic motor worn.

• Increase relief valve

pressure by turning relief

valve screw inward.

• Replace Hydraulic motor.

Bearing will not take

grease.

• Grease fitting clogged. • Replace fitting

Cutter head swings faster

one way than the other.

• Counter balance valve is

out of adjustment.

• Adjust counter balance

valve to equalize swing

speed.

Track too loose.

• Tensioning cylinder too

low on grease.

DO NOT OVER GREASE

TRACKS WILL BOW

• See Maintenance Section

on Tensioning Tracks.

For all Radio Transmitter or Receiver problems, see the Radio Control

Manual included at the back of this manual.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 100 101

Sin comentarios

Carlton SP8018 TRX Especificaciones Pagina 51