Carlton SP8018 TRX Especificaciones descargar pdf (Pagina 40)

100

101

SP8018 TRX TRANSPORTING

• THE TRAILER MUST BE SECURELY ATTACHED TO THE TOW VEHICLE

BEFORE LOADING OR UNLOADING THE STUMP GRINDER.

• DO NOT LOAD OR UNLOAD ON ANYTHING OTHER THAN LEVEL GROUND.

• Start engine as recommended by the

engine manufacturers manual.

• Increase engine RPM, raise cutter head

just off the ground.

• Position the machine behind the trailer

and close to the loading ramps. Push the

forward track controls on the remote

control and watch closely to make sure

both tracks stay on the ramps while

loading. KEEP THE MACHINE AS

LEVEL AS POSSIBLE.

• Continually adjust the cutter head height

as you go up the ramps, keeping the

mass as low to the ground as possible.

• When the machine is loaded, lower the

cutter head and shut down the engine.

• Secure the machine tightly with

sufficient tie downs to prevent any

movement in transit.

UNLOADING

• With trailer still securely attached to tow

vehicle, remove tie down straps and

make sure ramps are securely attached to

trailer and positioned correctly to unload

the machine.

• Start engine, increase RPM, and raise

cutter head to just clear the deck and

ramp.

• Continually adjust the cutter head up and

down to keep the mass as low to the

ground as possible.

• Raise cutter head and proceed to the

work site using extreme caution on hills

and uneven terrain. Use the gear and

flow controls in high position to get to

the job site faster and use the gear and

flow controls in low to make climbing

easier. See the Machine Controls

section for more information.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 100 101

Comentarios a estos manuales

Sin comentarios

Carlton SP8018 TRX Especificaciones Pagina 40

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Carlton SP8018 TRX