Carlton SP8018 TRX Especificaciones descargar pdf (Pagina 32)

SP8018 TRX MACHINE CONTROLS

• Use the radio transmitter to operate the

machine when positioning the machine

at the job site and when grinding the

stumps. The five operation and

positioning functions operate the same

on the machine as on the radio

transmitter. The radio transmitter has a

sixth control switch that will move both

of the tracks at the same time in the

forward or reverse directions only.

There is also a switch to control the Gear

and Flow on the radio transmitter. See

Hydraulic Controls listed in this section

for more information.

• The E-STOP button turns off the

transmitter and the machine when it is

pressed down.

• To run the machine by the toggle

switches, put the machine switch in the

Machine On position and turn the key

switch while pressing the by-pass switch

to start. The machine-mounted controls

can now be operated but not the radio

control.

• The machine-mounted controls are

toggle switches and automatically go

back to the off position in the middle

when released. These switches can be

used for short-term operation to position

the machine or to test the operation of

the functions. DO NOT GRIND

STUMPS USING THE MACHINE

MOUNTED CONTROLS, INJURY

COULD OCCUR.

PUSH SWITCH DOWN

TO MACHINE ON

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 100 101

Sin comentarios

Carlton SP8018 TRX Especificaciones Pagina 32