Carlton 1712 Manual del operador descargar pdf (Pagina 49)

12” CHIPPER MACHINE CONTROLS

FRONT JACK STAND

• Use the front jack stand anytime the

chipper is removed from the tow vehicle.

Do not depend on this jack stand to

support the machine for stand-alone

operation by itself. The tires must be

blocked using wheel chocks and the rear

jack stand must be used. The front jack

stand can be attached to the tongue on

either side of the machine. The jack

stand can then be rotated up and stored

on either side of the machine during

transport.

FEED WHEEL CLEAN OUT DOOR

• There is a drop-down door to clean

excess debris out from under the bottom

feed wheel. This will help to keep the

chipper from getting clogged or stopped

up. Use the handle on the clean out

door, located behind the infeed chute

under the machine, and drop the door

down to remove debris, then close and

secure the door. Should be cleaned

frequently to prevent damage to clean

out door and to prevent clogging the

chipper. DO NOT open the clean out

door until the chipper has been shut

down and all parts have come to a

complete stop, danger of flying debris

could cause injury.

STAND ALONE OPERATION

FRONT JACK STAND

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 164 165

Sin comentarios

Carlton 1712 Manual del operador Pagina 49